Cast Resin Distribution Transformer Winding Rules

Cast resin distribution transformer also play an important role in the process of our production and life. When a dry-type transformer is opened, a lot of windings will be seen. The windings of dry-type transformers have certain rules. .

1. The wiring is uniform and tight;

2. There is no knot, no cross, no overlap, and the upper layer does not fall into the next layer.

Uniform winding means that the distance between the lines is roughly equal, and the entire winding area is wrapped around the entire winding area. The cast resin distribution transformer winding line should be close to the end control tape, but the upper end control tape is not allowed.

1. The winding is wound around the entire winding area;

2. The distance between the lines is roughly equal;

3. The take-up and take-up lines are wound by the end control tape, and there is no upper end control.

Two or more wires should be wound in parallel to the same group of wires at the same time, and they should be wound in parallel, and they should not cross.

This winding method can be roughly divided into four cases:

a, the same group and winding;

b. Different groups are wound in parallel;

c. Multiple groups are wound in parallel;

d. Double winding in different groups or in the same group.

Cast resin distribution transformer lines are closely close to each other, and the winding center line cannot be layered or crossed. For example, when one layer is densely wound, no second layer is allowed, and no gap between the wires is allowed. and crossovers.